Seals

Seals




The seal on the A pillar is glued to a retainer screwed onto the pillar. At the bottom, the seal is held in place by three fasteners and double- sided adhesive tape. At the top, the strip is secured by one fastener and contact adhesive.

The top has a seal at the front, one on either side and two at the rear.

The seal at the front is glued and screwed to the no. 1 crossmember stand, on either side, glued to a retainer that is screwed to the side rails of the top frame. Sealant is applied at the corners.

The intermediate seal on either side is glued to a seal retainer screwed onto the middle section of the side rail.

The rear seals are glued, screwed and secured by ties to the side rail rear sections. These seals also serve as guides for the quarterlights.