Installation Procedure, 9000 Models, 1986-88 Only

1. Remove the glove compartment from the dash.

2. Remove the Saab Guard module and adapter harness leaving the blue and violet wires for the LED.

3. Refer to Step 2 of the 900 installation procedure for setting the arming mode.

4. Secure the Alpine module in a suitable location behind the glovebox.

5. Remove the glass breakage microphone from its bracket and install it in one of the blank switches on the dash or make a hole in the trim panel below the glove box and mount the flat metal bracket to the panel using a sheet metal screw and a speed nut (not supplied with kit).

6. Connect the microphone wire to the jack marked "input" on the Alpine module.

7. Connect the Alpine harness to the module and to the 8-pin plug in the car. Connect the blue wire from the LED to the violet wire of the alarm harness. Connect the violet wire from the LED to the black/red wire of the alarm harness.

8. Test the alarm function and reinstall the glove box.