Tools - Modification for 9000 M/T
86saab01FILE IN S.I. Man VOL. I
SEC. B-1 PG. 10
Service Information
SUBJECT: MODIFICATION OF SPECIAL TOOLS ISSUE: 05/86-843 FOR 9000 MANUAL TRANSMISSION
APPLICATION: PULLER JAMS P/N 87-91-295 AND P/N 87-91-303
Due to production running changes, puller jaws P/N 87-91-295 and 87-91-303 must be modified before they can be used for dismantling the 9000 manual transmission. These puller jaws were delivered to you during early May (see MEMO TSB-6-006) with the Phase II tool shipments.
See the following text and drawings for performing the modifications.
The modifications require the use of a bench grinder. Use caution when using electric tools and be sure to wear adequate eye protection!
Puller Jaws P/N 87-91-295
1. Narrow the jaws from 25 mm to 21 mm as shown by the shaded area in the drawing.
2. Grind off the bottom until a dimension of 6.5 mm is achieved.
Puller Jaws P/N 87-91-303
1. Grind off the bottom of the jaws as shown by the shaded area until a dimension of 6.5 mm is achieved.