Campaign - Oil Pressure Switch Inspection
85saab03FILE IN VOL.
SEC. A-2 PG. 193
Service Information
SUBJECT: INSPECTING CARS FOR DEFECTIVE ISSUE: 12/85-813 OIL PRESSURE SWITCH
APPLICATION: EARLY M86 900, 900S MODELS
Contents of this S.I.: SERVICE CAMPAIGN
Introduction p. 1
513
Owner Notice p. 1
Parts Involved p. 2
Warranty Information p. 2
Inspection Procedure p. 2
Introduction
This service campaign involves early M86 900 and 900S model Saabs. A new oil pressure switch was introduced on these vehicles and some of these switches were found to be defective. As a result of the defect, an oil leak could develop.
Purchasers of affected vehicles will receive a service campaign notice directly from Saab-Scania of America informing them of the possibility of an oil leak. The owner notices will be sent on or about January 20, 1986, but not before you have received your initial quantities of replacement parts. Initial order of parts will equal 50% of the cars on your status list and will be shipped about the time you receive this S.I.
Owner Notice
The owner notice pictured here will be sent to owners of the following M86 vehicles:
^ M86 900, 900S models with Engine Serial Nos. G000001 - G017894
Parts Involved
The following part will be sent to your dealership in a quantity equaling 50% of those vehicles listed on your status list. Order any additional supplies as needed.
Oil Pressure Switch P/N 75-22-402
Warranty Information
Use a regular warranty claim as in all Saab Service Campaigns. Follow the claim instructions given below. No additional parts or time may appear on the claim.
Failure Code: 10391-05-0-02-01
Parts Allowance: 75-22-402 OIL PRESSURE SWITCH $6.80
Labor Allowance: Inspect and replace the oil pressure switch, if necessary. Use Labor Operation #10391 for 0.2 hour.
Inspection Procedure
Remove the oil pressure switch and take note of the date code stamped into the switch.
If the switch was produced in June 1985 or before (month codes A-F), replace the switch. If the switch was produced in July 1985 or later, it is O.K. and can be re-installed (month code G or above).
See the drawing for identifying the date code.