Throttle Body: Service and Repair

REMOVAL
1. Disconnect negative cable from battery
2. Disconnect air intake duct from throttle body.
3. Remove throttle cable bracket.
4. Disconnect electrical connectors.
5. Disconnect top vacuum hose.
6. Remove 3 throttle body bolts.
7. Hold throttle lever in wide open position. Remove throttle cable and speed control cables from throttle arm.
8. Clean mating surfaces.

INSTALLATION
1. Hold throttle lever in wide open throttle position. Install throttle cable and speed control cable.
2. Install throttle body and bolts.
3. Tighten bolts to 12 Nm (106 in. lbs.) torque.
4. Install vacuum hose.
5. Install throttle cable bracket and tighten bolts.
6. Install air intake duct and tighten clamp.
7. Connect negative cable to battery.