Removal and Installation

REMOVAL
It is necessary to remove the oil pan, oil pickup and oil pump body to service the oil pump rotors. The oil pump pressure relief valve can be serviced by removing the oil pan.
1. Remove radiator fan module for access to timing belt covers and crankshaft damper.
3. Remove the crankshaft damper and timing belt covers.
4. Remove timing belt.
5. Remove crankshaft sprocket.
6. Remove oil pan.
7. Remove oil pickup tube.





8. Remove oil pump fasteners. Remove oil pump and gasket from engine (Fig. 110).

INSTALLATION
1. Prime oil pump before installation by filling rotor cavity with engine oil.
2. Install gasket and oil pump carefully over the crankshaft and into position. Install and tighten bolts to 28 Nm (250 in. lbs.).
3. Install new O-ring on oil pickup tube.
4. Install oil pickup tube.
5. Install oil pan.
6. Install crankshaft sprocket.
7. Install timing belt.
8. Install the timing belt covers and crankshaft damper.
9. Install the accessory drive belts.
10. Install radiator fan module.
11. Install new oil filter.
12. Fill crankcase with specified type and amount of engine oil.