Owner Letter

EMISSIONS RECALL --
1990 EAGLE SUMMIT, PLYMOUTH AND DODGE COLT WITH 1.6 LITER DOHC ENGINE


Dear Chrysler Motors Vehicle Owner:

Recently we learned that an inaccurate vacuum hose routing diagram label was installed on your car. The label incorrectly showed two hoses reversed. In the event that your car's vacuum hoses were ever rerouted during subsequent service to match the label, your car would likely not drive properly or meet government emission standards. Additionally, certain states inspect this label as a part of an emission testing program. For these reasons we ask that you apply the enclosed label so that It covers the existing wrong label which is located on the underside of the hood. To assure good adhesion, it will be necessary to wipe the existing label clean before you apply the new label.

If you prefer not to perform the installation yourself, contact your dealer to make an appointment for the label application. This service will be provided free of charge. Take the enclosed Owner Recall Notification Form and label with you at the time of your appointment and give them to your dealer. The form identifies the vehicle and recall for which service is required.

If you have any problem obtaining the service, please contact the Chrysler Zone Service Office in your area. (It is listed under "Service Assistance" in your Operator's Manual.) A Zone representative will arrange for prompt servicing of your vehicle. If you are still unable to obtain the repair as described in this letter within a reasonable time, you may also contact the Manufacturers Operations Division of the Environmental Protection Agency (EN-340F), 401 M Street S.W., Washington, D.C. 20460.

We regret any inconvenience this action may cause you. However, we believe the correction is necessary to help ensure that your car will meet state inspection program requirements.

Thank you for your prompt attention to this important matter.