Rear Axle

REMOVAL
1. Remove axle shaft and position on a work bench.





2. Using a thin-blade cold chisel between rear brake anti-lock sensor indicator and axle shaft, strike chisel evenly around flange forcing rear brake anti-lock sensor indicator off rear brake anti-lock sensor indicator journal. Discard rear brake anti-lock sensor indicator.

CAUTION: Use only a cold chisel, not a screwdriver. Extreme care should be taken not to scratch or nick rear wheel bearing and seal journal and rear brake anti-lock sensor indicator journal.

NOTE: Prior to installation of new rear brake anti-lock sensor indicator, remove any burrs or nicks from journal.





INSTALLATION





1. Position Sensing Ring Replacer 206-057 (T94P-20202-A) on Axle Bearing / Seal Plate 205-090 (T75L-1165-B), placed on press bed as shown.





2. Place new rear brake anti-lock sensor indicator over Sensing Ring Replacer 206-057 (T94P-20202-A).





3. Insert axle shaft through tool.





4. Place Pinion Bearing Cup Replacer 205-231 (T85T-4616-AH) over hub end of axle shaft.





5. Press axle shaft until it bottoms out on axle flange.
6. Install axle shaft.