Post-Service Procedures

After the service is complete and the fuel charging system is installed to engine, the following steps must be taken:
1. Install fuel tank filler cap at fuel tank.
2. Connect battery ground cable.
3. Add engine coolant if required.
4. Turn ignition switch from RUN to OFF several times without starting engine to check for fuel leaks.

WARNING: THE FUEL SYSTEM IS NORMALLY PRESSURIZED TO 276 kPa (40 PSI). USE CARE WHEN SERVICING THE FUEL SYSTEM OR PERSONAL INJURY MAY OCCUR.

NOTE: Check all connections at fuel injection supply manifold, fuel injectors and fuel line push connect fittings.

5. Start engine and warm to operating temperature. Check for engine coolant leak if coolant was removed.
6. Perform Powertrain Control Module (PCM) Self-Test to check systems function.