AR67.30-P-4200-06QA Basic Adjustment For Height Stop on Rear Side Power Window

AR67.30-P-4200-06QA Basic Adjustment For Height Stop On Rear Side Power Window

Test Values For Rear Side Window:

Side Windows:

The rear side window (2) must be installed for adjustment operations on power window.

1. Loosen mounting bolt (1) on height stop (3) at bottom.
2. Lower rear side window (2) to dimension (e).
3. Check dimension (e), if required, raise rear side window (2) or lower.
4. Position mounting bolt (1) on rear side window (2) with stop bracket (2) and tighten. [Nm]
5. Lift rear side window (2) and lower and check dimension (e) again.
6. If dimension (e) is not reached, repeat adjustment.







7. Loosen height stops (3).
8. Lift door window (4) until door window (4) and rear side window (2) are flush at same height.
9. Tighten height stops (3). [Nm]
10. Lower door window (4) and lift to end stop.
11. Check whether door window (4) and rear side window (2) are flush with one another.
12. If they are not flush repeat adjustment.







13. Move rear side window (2) 15 mm beyond top dead center.
14. Adjust rear side window (2) parallel to top edge of shaft flange above adjusting screws (5). [Nm]
15. Measure if they are parallel (f), repeat adjustment, if necessary.