Voice Activated CD Changer/Cell Phone Installation: Overview

Date: August 2OOO

Order No.: P-SI-82.64/139

Supersedes:

Group: 82

SUBJECT:
MODEL: 208.365/370/374
MODEL: YEAR 2001
VOICE ACTIVATED CELLULAR TELEPHONE/CD CHANGER INSTALLATION

WARNING:
Disconnecting the negative battery cable is not recommended due to otherwise extensive reprogramming requirements. WIRING HARNESSES WILL BE ELECTRICALLY ACTIVE. IT IS THEREFORE NECESSARY TO EXERCISE EXTREME CAUTION WHILE EXECUTING THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO. COULD RESULT IN SEVERE VEHICLE DAMAGE. PERSONAL INJURY OR DEATH FROM ELECTRICAL SHOCK. The ignition and radio power must remain OFF until the final test is performed.

Application specific D2B notes:

^ CD changer, telephone, and voice recognition module fibers are installed at the factory. Telephone and voice recognition fibers run along the left rear quarter panel and the CD fibers along the right rear quarter panel.

^ TeleAid 2 fibers are installed at the factory only if the vehicle is equipped with COMAND.

^ The vehicle is configured from the factory for the CD changer only.

^ Two sets of fiber cables run along the left quarter panel. One set is for the telephone only and the other for telephone and voice recognition. While not in the factory configured ring, these fibers are coupled together just forward of the battery on the right. Which set of fibers to use will depend on whether the telephone only or telephone with voice recognition will be installed.