Radio - Cellular Phone/CD Changer Installation: Overview

Order No.: P-82_64-129

Group: 82

Date: February 2000

Subject: VOICE ACTIVATED CELLULAR TELEPHONE/CD CHANGER INSTALLATION

MODEL 208.365/370

MODEL YEAR 2000

WARNING! Disconnecting the negative battery cable is not recommended due to otherwise extensive reprogramming requirements. WIRING HARNESSES WILL BE ELECTRICALLY ACTIVE. IT IS THEREFORE NECESSARY TO EXERCISE EXTREME CAUTION WHILE EXECUTING THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO, COULD RESULT IN SEVERE PERSONAL INJURY OR DEATH FROM ELECTRICAL SHOCK. The ignition and radio power must remain OFF until the final test is performed.

Application Specific D2B Notes:

^ CD changer, telephone, and voice recognition module fibers are installed at the factory. Telephone and voice recognition fibers run along the left rear quarter panel and the CD fibers along the right rear quarter panel.

^ The vehicle is configured from the factory for the CD changer only.

^ Two sets of fiber cables run along the left quarter panel. One set is for the telephone only and the other for telephone and voice recognition. While not in the factory configured ring, these optics are coupled together just forward of the battery on the right. Which set of optics to use, will depend whether the telephone only or telephone with voice recognition will be installed.

^ All reconfiguration points are in the trunk in front of the battery and to the right of the fuse panel.

Parts Information (CD Changer):

PARTS INFORMATION (CD CHANGER)

PARTS INFORMATION (PORTABLE TELEPHONE)

Parts Information (portable Telephone):

*Handset type depends on client's selection of cellular carrier and operating region. Contact the Technical Assistance Hotline @ 1-877-MOT-8600 (1-877-668-8600) for assistance in determining the correct portable handset.

Parts Information (telephone Installation Kit):

PARTS INFORMATION (TELEPHONE INSTALLATION KIT)

Parts Information (voice Recognition System):

PARTS INFORMATION (VOICE RECOGNITION SYSTEM)