Installation of the Completed Bracket Assembly

D. Installation of the Completed Bracket Assembly





1. Place the completed bracket assembly near the installation point (Figure 4).

2. Connect the 25-pole D-connector from the telephone Y-cable to the vehicle harness.

3. Connect the 15-pole D-connector from the vehicle harness to the optional VRM (if so equipped).

Note: Be sure to read the application specific D2B notes on near the beginning of this bulletin for information on the fiber optics to be used for the installed configuration.

4. Connect the fiber pair labeled TEL to the PSE optical cavity.

5. If installing the optional voice recognition system. connect the fiber pair labeled SBS to the VRM. Leave the pair labeled TEL/SBS capped and off to the side if not installing the voice recognition system.

6. Connect the 9O° mini-UHF connector from the front center console to the linear compensator RF jack labeled Portable.

7. Connect the remaining RF lead, from the integrated bumper antenna, to the linear compensator RF jack labeled Antenna.

8. Seat the bracket in the quarter panel cavity and fasten it with three (3) M6 flange nuts.





9. Route all cables neatly around the control units and bracket assembly (Figure 5).

Note: Fiber optic cables must be handled with care, free of kinks, bends, and abrasions.