Removing and Installing Crankshaft Sprocket

Preceding work:
- Oil sump removed.
- Tensioning rail removed. Removing and Installing Tensioning Rail
- Guide rail removed. Removing and Installing Guide Rail In Cylinder Head




- Unbolt (32 Nm) Oil pump drive gear (6) at oil pump (7).
- Remove Oil pump chain (8) and oil pump drive gear (6).
- Note: Pay attention to installation of oil pump pump drive gear (6).
- Pull off Tensioning bar (9), bush (10) and spring (13).
- Remove Timing chain (14).



- Pull off Crankshaft sprocket (11).
- Using tool 615 589 01 33 00.
- Note Parallel keys (12).
- Heat fit on Crankshaft sprocket (11).