Up to 6/93

Routing of cable of electronic accelerator modified
Model 124.036 up to 06 93
Model 124.036






1 Remove scissors-type bush (5) from the component compartment wall, install. Fold open scissors-type bush (5) and pull out cables.
2 On models up to engine ident no. 001910 replace shaped hoses (3, 4) for the crankcase ventilation and route as shown in the illustration.
Shaped hose (3), part no. 119 094 6282
Shaped hose (4), part no. 119 O94 5582
3 Electric cable (1) of accelerator pedal actuator and also the securing clip (2) must be installed as shown in the illustration.


NOTE: The white marking (arrow) must be installed within the securing clip (2). The markings which are otherwise provided all round are identified on this cable as a white rectangle.






4 Route all the electric cables (1, 6, 7) and also the coolant pipe of the heating water return (8) through the holes (6, 7, 1, 8) of the scissors-type bush (5). Press scissors-type bush together.






NOTE: It is absolutely essential to keep to the order for routing the cables and pipes through the holes of the scissor-type bush.