Removal and Replacement
Removal and Installation of Rear BumperA. Sedan
Removal, installation:
1. Unscrew fastening nuts outside left and right.
2. Unscrew nuts on rear center piece.
3. Take out front fastening bolts on rear fender and remove bumper in rearward direction.
4. For further installation proceed in reverse order.
B. T-model
1. Remove or open trim at side in loading space.
2. Remove spare wheel.
3. Unscrew fastening nuts outside left and right.
4. Unscrew nuts on rear center piece.
5. Loosen trim at rear of loading space recess and unscrew the two fastening nuts in rear center piece.
6. Extend front fastening bolts on rear fender and remove bumper toward the rear.
7. Check or mount seal and holder laterally on fender.
Installation note:
When installing bumper, make sure that the eye on the side of the bumper is plugged into holder.
8. For further installation proceed in reverse order.