Procedures

Removal, disassembly, Assembly and Installation of Center Floor Shift





Illustration Key

1 Bearing bracket - Check for damage and bearing points for wear, grease during assembly
2 Selector lever - Check for damage
3 Guide block (shift pattern) - Check for damage
4 Rubber gasket - Check for damage
5 Housing
6 Hex. head screws
7 Light guide - Attention! Do not bend light guide, for removal pay attention to item 3.
7a Light wire
8 Cover strip
9 Cover
11 Holder - Remove during disassembly, check for damage, replace if necessary
12 Counternut
13 Fork head - Check for wear
14 Double leg spring
15 Plastic bushings - Check for wear
16 Fuse
17 Bearing bolt - Check for wear (1)
18 Shaft - Check for wear (1)
19 Circlip
20 Washer
20a Corrugated washer
21 Bearing bushings - Check for wear
22 Gasket
23 Switch - selector lever position "B - During removal, slide slightly forward and remove laterally
25 Sleeve - Check for damage and cracks
26 Holder
27 Valve
28 Valve holder - Check for function
29 Plug
30 Glow bulb

(1) Longterm lubricant Longterm 2 or Olistamol.

Removal and installation





1 Remove clip lock (49) and disengage shift rod (10).





2 Remove cover (arrow), and or remove center console.





3 Pull light guide (7) for illuminating guide block (shift pattern) from distributor (8) or pull glow bulb out of housing and pull plug from switch on vehicles with selector lever position "B" as well as with "S" and "E" programs





4 Unscrew fastening screws (6), remove center floor shift.

Installation Note
During installation, place gasket on center floor shift and insert fastening screws through gasket.

5 For installation proceed vice versa.





6 Align selector lever (2) so that the bend (arrow) points forward and the contour separating line on plastic foam (top view in drawing) runs accurately in longitudinal direction of vehicle.
7 Tighten counternut (12).