General

Data:
- Designation
Delco (Frigidaire) radial 4-cylinder
- Max. speed
7000 1/Min
- Required output at max. compressor speed
approx. 6.3 kW (8.5 HP)
- Cylinder capacity
164 cm3

Oil Capacity:
- Oil type refrigerant oil (for approved refrigerant oils refer to "Specifications" for service products.
- Oil quantity, new, in refrigerant compressor
170 cm3

Tightening Torques:
- Screws (8) pulley-coupling body
11 Nm (1.1 kpm)
- Screw M 10 x 30 pipe line to refrigerant compressor
50±3 Nm (5±3 kpm)
- Nut (1) on drive shaft
13 Nm (1.3 kpm)
- Screws (5 and 6) M 12 refrigerant compressor to carrier
60+10 Nm (6+1 kpm)
- Hose line (14) from evaporator to pipe line 7/8"
29-37 Nm (2.9-3.7 kpm)
- Hose line (15) from pipe line to condenser 3/4"
24-28 Nm (2.4-2.8 kpm)

Special Tools:
- Holding device for refrigerant compressor
116 589 14 31 00
- Holding wrench for coupling
116 589 04 40 00
- Remover for coupling plate
000 589 07 35 00
- Installer with spacing member for spring plate
000 589 49 43 00
- Guide member
116 589 05 63 00
- Two-claw puller
000 589 88 33 00
- Knock-out mandrel
115 569 02 35 02
- Remover and installer for slip ring
000 589 21 61 00
- Remover and installer for shaft seal
000 589 65 63 00
- Pressure test plate for refrigerant compressor
109 589 00 25 00

Conventional Tools:
- Socket 14 mm. 3/8" square
e.g. made by Hazet, 5630 Remscheid
- Slip gauge (set)
e.g. made by Hazet, 5630 Remscheid - order no.2147
- Langbeck pliers 72A (inside lock)
e.g. made by Hazet, 5630 Remscheid - order no.1846 a-1
- Pliers for locking ring J 2 (outside lock)
e.g. made by Hazet, 5630 Remscheid - order no.1846 c-2
- Double open end wrench
1/2" x 9/16", 5/8" x 3/4", 7/8" x 15/16", 1" x 1 1/8"

Self-Made Tool:
- Remover for 0-ring