Rear Washer Hose Removal/Installation
REAR WASHER HOSE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front bumper. Removal and Replacement
3. Disconnect rear washer hose A from the washer motor.
4. Remove clips A, B, and C.
5. Disconnect rear washer hose A from joint pipe A and remove it.
6. Remove the tape joining the grommet and rear washer hose B.
7. Remove clips D.
8. Disconnect rear washer hose B from joint pipe A.
9. Remove the following parts:
a. A-pillar trim A-Pillar Trim Removal/Installation
b. Sunvisor Service and Repair
c. Map light Map Light Removal/Installation
d. Assist handle Service and Repair
e. Front scuff plate Front Scuff Plate Removal/Installation
f. Rear scuff plate Rear Scuff Plate Removal/Installation
g. B-pillar lower trim B-Pillar Lower Trim Removal/Installation
h. Front seat belt anchor cover Front Seat Belt Removal/Installation
i. Front seat belt upper anchor installation bolt Front Seat Belt Removal/Installation
j. B-pillar upper trim B-Pillar Upper Trim Removal/Installation
k. Sub-trunk Sub-Trunk Removal/Installation
l. Trunk end trim Trunk End Trim Removal/Installation
m. Third-row seat Rear - Third-Row Seat Removal/Installation
n. Third-row seat belt lower anchor installation bolt Third-Row Seat Belt Removal/Installation
o. Cargo compartment light Service and Repair
p. Trunk side trim
q. Second-row seat belt upper anchor installation bolt Second-Row Seat Belt Removal/Installation
r. Rear header trim Rear Header Trim Removal/Installation
s. C-pillar trim C-Pillar Trim Removal/Installation
10. Disconnect rear washer hose B from joint pipe B and remove it.
11. Disconnect rear washer hose C from joint pipe B.
12. Disconnect rear washer hose C from joint pipe C.
13. Disconnect rear washer hose D from joint pipe C.
14. Remove the headliner. Service and Repair
15. Mark the antenna feeder and headliner so that the position of tape A can be determined after removal.
16. Remove tape A, then remove rear washer hose C and antenna feeder as a single unit.
17. Measure the length from the end of the antenna feeder to the end of rear washer hose C so that the fixed position of rear washer hose C and antenna feeder can be determined after tape B removal.
18. Mark the antenna feeder so that the position of tape B can be determined after removal.
19. Remove tape B, then remove rear washer hose C from the antenna feeder.
20. Remove the liftgate upper trim.
21. Remove clip E.
22. Disconnect rear washer hose D from the rear washer nozzle and remove it.
23. Install in the reverse order of removal.
Rear Washer Hose C Installation Note
1. Align rear washer hose C and antenna feeder to the position measured before removing tape B.
2. Wrap tape B to the marked position of the antenna feeder, and secure it with rear washer hose C.