Sliding Door Glass Removal/Installation

SLIDING DOOR GLASS REMOVAL/INSTALLATION

1. Fully open the sliding door glass.

2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Side door garnish Side Door Garnish Removal/Installation

b. Rear side trim Rear Side Trim Removal/Installation

c. Sliding door trim Service and Repair

d. Sliding door quarter glass Sliding Door Quarter Glass Removal/Installation

4. Connect the power window subswitch connector.

5. Connect the negative battery cable.

6. Adjust the door glass position as shown in the figure.






7. Disconnect the negative battery cable.

8. Remove the screws.






9. Remove the service hole cover in the direction of the arrow (1), then remove the service hole cover in the direction of the arrow (2) while avoiding the wires.






10. Remove the hole plug.






CAUTION:




- If the bolts are removed without supporting the sliding door glass, the glass may fall off. Insert a hand through the service hole and lower the sliding door glass to the bottommost position while supporting the glass with your hand.

11. Remove the bolt.






12. Remove the sliding door glass in the direction of the arrow as shown in the figure.






13. Install in the reverse order of removal.