Steering Angle Sensor: Service and Repair

STEERING ANGLE SENSOR REMOVAL/INSTALLATION

WARNING:
- Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings and cautions before handling the air bag module. Air Bag System Service Warnings Air Bag System Service Cautions

1. Switch the ignition OFF (LOCK).

2. Disconnect the negative battery cable and wait for 1 min or more.

3. Remove the following parts:
a. Driver-side air bag module Two-Step Deployment Control System Standard Deployment Control System

b. Steering wheel Service and Repair

c. Column cover Service and Repair

d. Clock spring Service and Repair

4. Remove the tabs shown in the figure.






5. Pull the steering angle sensor in the direction of the arrow shown in the figure and remove the pin from the clock spring.






6. Install in the reverse order of removal.

7. Perform the steering angle sensor initialization. Programming and Relearning