Door Lock-Link Switch Inspection

DOOR LOCK-LINK SWITCH INSPECTION

Front Door Lock-Link Switch Inspection

1. To access the glass installation bolt, adjust the position of the front door glass so that the height of the door glass towards the rear is approx. 105 mm {4.13 in}.






2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Inner garnish Inner Garnish Removal/Installation

b. Front door trim Front Door Trim Removal/Installation

c. Front door speaker Front Door Speaker Removal/Installation

d. Front door glass Front Door Glass Removal/Installation

e. Front inner handle Service and Repair

f. Front door module panel Front Door Module Panel Removal/Installation

g. Front door latch and lock actuator Service and Repair

4. Operate the door lock link switch cable and verify that the continuity the at lock/unlock position is as indicated in the table.
NOTE:
- The door lock-link switch cable locks or unlocks only when the latch lever is locked.






- If not as indicated in the table, replace the front door latch and lock actuator.






Sliding Door Lock-Link Switch Inspection

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Side door garnish Side Door Garnish Removal/Installation

b. Rear side trim Rear Side Trim Removal/Installation

c. Sliding door trim Service and Repair

d. Sliding door inner handle Service and Repair

e. Remote controller Service and Repair

f. Sliding door lock actuator Sliding Door Lock Actuator Removal/Installation

3. Operate the door lock-link and verify that the continuity at the lock/unlock position is as indicated in the table.






- If not as indicated in the table, replace the sliding door lock actuator.