Air Bag Control Module: Service and Repair
SAS CONTROL MODULE REMOVAL/INSTALLATION
WARNING:
- Handling the SAS control module or air bag module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. Air Bag System Service Warnings Air Bag System Service Cautions
- If the connector is connected and the ignition switch is turned to the ON position with the SAS control module not secured completely using the installation nuts, the SAS control module may detect a degree of impact even when something contacts it lightly, deploying the air bag module and pre-tensioner seat belt accidentally.
- If the DSC sensor initialization procedure is not completed, it could result in an unexpected accident due to the DSC being inoperative. Therefore, after the SAS control module is replaced, always perform the DSC sensor initialization procedure to ensure proper DSC operation. (See Programming and Relearning)
CAUTION:
- When replacing the SAS control module, always perform the configuration procedure before removing the SAS control module. If the configuration is not performed and the SAS control module is removed, DTC B2477 will be displayed.
1. Perform SAS control module configuration when replacing it. Testing and Inspection
2. Switch the ignition to off.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove the following parts:
a. Side wall Side Wall Removal/Installation
b. Center console box Center Console Box Removal/Installation
c. Console panel Console Panel Removal/Installation
d. Center console Center Console Removal/Installation
e. Shift lever knob (MTX) Service and Repair
f. Selector lever knob (ATX) Automatic Transaxle Shift Mechanism Removal/Installation
g. Shift panel Shift Panel Removal/Installation
h. Front console Front Console Removal/Installation
i. Rear blower unit Rear Blower Unit Removal/Installation
5. Disconnect the connector A.
6. Disconnect the connector B.
7. Remove the bolts.
8. Remove the SAS control module.
9. Install in the reverse order of removal.
10. Switch the ignition to ON.
11. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
- If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system. Two-Step Deployment Control System Standard Deployment Control System
Connector A Connection Note
1. Verify that the connector A lever is tilted towards the wiring harness side as shown in the figure.
2. Insert the connector A straight until it contacts the SAS control module and verify that the lever reverts upward naturally.
CAUTION:
- If the connector A is inserted at an angle and the lever is moved, the connector could be damaged. Verify that the connector A is inserted straight.
3. Push the lever until a click is heard.