Pressure Regulating Solenoid: Service and Repair
SOLENOID VALVE REMOVAL/INSTALLATION [FS5A-EL]
WARNING:
- Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury.
- Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes.
CAUTION:
- Do not allow foreign material or water to penetrate the connector. Otherwise, it could cause poor contact and corrosion.
Primary Control Valve Body
1. Remove the primary control valve body.
a. Remove the battery cover. Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the aerodynamic under cover. Service and Repair
d. Clean the outside of the transaxle using steam or detergent oil.
e. Drain the ATF. Automatic Transaxle Fluid (ATF) Replacement
f. Remove the oil pan. Service and Repair
g. Remove the primary control valve body. Service and Repair
2. Remove in the order shown in the figure.
3. Install in the reverse order of removal.
4. Add ATF. Automatic Transaxle Fluid (ATF) Replacement
5. Perform the mechanical system test. Mechanical System Test
6. Perform the road test. Road Test
Secondary Control Valve Body
1. Remove the secondary control valve body.
a. Remove the battery cover. Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the battery. Removal and Replacement
d. Remove the battery tray. Removal and Replacement
e. Remove the aerodynamic under cover. Service and Repair
f. Clean the outside of the transaxle using steam or detergent oil.
g. Drain the ATF. Automatic Transaxle Fluid (ATF) Replacement
h. Remove the oil cover. Service and Repair
i. Remove the secondary control valve body. Service and Repair
2. Remove in the order shown in the figure.
3. Install in the reverse order of removal.
4. Add ATF. Automatic Transaxle Fluid (ATF) Replacement
5. Perform the mechanical system test. Mechanical System Test
6. Perform the road test. Road Test
