Rear Combination Light Removal/Installation

REAR COMBINATION LIGHT REMOVAL/INSTALLATION

NOTE:
- Fogging or condensation on the inside of the rear combination light may occur, however, it is a natural phenomenon occurring as a result of a temperature difference between the interior and exterior of the combination lights and has no effect on the light performance. Fogging or condensation will dissipate when the temperature inside the rear combination lights rises after illuminating the brake/taillight bulbs and a period of time has elapsed.

1. Disconnect the negative battery cable.

2. Remove the screws.






3. Pull the cover in the direction of the arrow to detach the clip A.






CAUTION:
- If excessive force is applied to the cover when detaching clip A, the cover could be deformed or damaged. When detaching clip A, apply force to the shaded area in the figure and pull clip A to detach it.






4. Pull the rear combination light in the direction of the arrow to detach the hook from clip B.






5. Remove the sockets.






6. Remove the rear combination light.

7. Remove the cover in the direction of the arrow (2) shown in the figure while pressing the cover tabs in the direction of the arrow (1).






8. Install in the reverse order of removal.