Sliding Door Lock Actuator Inspection

SLIDING DOOR LOCK ACTUATOR INSPECTION

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Side door garnish Side Door Garnish Removal/Installation

b. Rear side trim Rear Side Trim Removal/Installation

c. Sliding door trim Service and Repair

d. Sliding door inner handle Service and Repair

e. Remote controller Service and Repair

f. Sliding door lock actuator Sliding Door Lock Actuator Removal/Installation

3. Connect the sliding door lock actuator terminals to the battery positive voltage and the ground, and verify that the sliding door lock actuator operates as indicated in the table.









- If the sliding door lock actuator does not operate as indicated in the table, replace it.