Keyless Entry Receiver: Testing and Inspection

KEYLESS RECEIVER INSPECTION

1. Remove the following parts:
a. Rear scuff plate (LH) Rear Scuff Plate Removal/Installation

b. Sub-trunk Sub-Trunk Removal/Installation

c. Trunk end trim Trunk End Trim Removal/Installation

d. Third-row seat Rear - Third-Row Seat Removal/Installation

e. Third-row seat belt lower anchor installation bolt (LH) Third-Row Seat Belt Removal/Installation

f. Trunk side trim (LH)

2. Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).

- If the voltages cannot be verified as indicated in the terminal voltage table, inspect the parts under "Inspection item(s)".

- If the system does not operate normally even though the parts under "Inspection Item(s)" and related wiring harnesses do not have any malfunction, replace the keyless receiver.

Terminal Voltage Table (Reference)