C-Pillar Trim Removal/Installation

C-PILLAR TRIM REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Partially peel back the seaming welts.

3. Remove the following parts:
a. Rear scuff plate Rear Scuff Plate Removal/Installation

b. Sub-trunk Sub-Trunk Removal/Installation

c. Trunk end trim Trunk End Trim Removal/Installation

d. Third-row seat Rear - Third-Row Seat Removal/Installation

e. Third-row seat belt lower anchor installation bolt Third-Row Seat Belt Removal/Installation

f. Cargo compartment light Service and Repair

g. Trunk side trim

h. Rear header trim Rear Header Trim Removal/Installation

i. Third-row seat belt lower anchor installation bolt Third-Row Seat Belt Removal/Installation

j. Second-row seat belt upper anchor installation bolt Second-Row Seat Belt Removal/Installation

4. Remove the fasteners A.






5. Pull the C-pillar trim in the direction of the arrow in the order of (1), (2) and remove the C-pillar trim while detaching the clips B and pin C.






6. Slide the C-pillar trim in the direction of the arrow (3) shown in the figure and remove the C-pillar trim from clip D.

7. After removing the C-pillar trim, remove clips D from the body.

8. Install in the reverse order of removal.