Control Module: Testing and Inspection

TCM CONFIGURATION [FW6A-EL]

NOTE:
- The TCM is built into the control valve body.

1. Verify TCM configuration implementation necessity for replacement parts.





2. Connect the M-MDS (IDS) to the DLC-2.

3. After vehicle identification, the following can be selected from the IDS initialization screen.

- "Module Programming"

4. Then, select the following from the screen menu.

- "Programmable Module Installation"
- "TCM"

5. Perform the configuration following the instructions on the screen.

6. Verify that no DTCs are stored.
NOTE:
- If any DTC (U code) is output, the system is normal.

7. Delete the U code and verify that no DTC is output.

- If any DTC other than U code is output, repair the malfunctioning location according to the applicable DTC troubleshooting. Automatic Transmission/Transaxle - DTC Table FW6A-EL