Shift Control Module Assembly
SHIFT CONTROL MODULE ASSEMBLY1. Assemble the shift control module using the procedure shown in the figure.
Oil Seal Assembly Note
1. Assemble a new oil seal to the control case using the SST.
Clip Assembly Note
1. Move the guide pin to the position shown in the figure for the guide plate.
2. Push down the spring seat by hand.
3. Assemble the clip.
Pin Assembly Note
1. Secure the shift control module in a vise.
2. Align the switch pin and interlock sleeve markings.
3. Assemble a new pin (switch pin) using a punch.
4. Move the control lever component to set the guide pin to the 5GR position of the guide plate.
5. Assemble a new pin (control lever component) using a punch.