Visual Inspection of Parts

VISUAL INSPECTION OF PARTS

1. Visually inspect the parts according to the following table and replace a malfunctioning part with a new one.

NOTE: Check the color depending on the condition to specify the malfunctioning part.






2. Verify that there is no bushing adhesion trace or significant sliding trace on the following bushing sliding part.






- Torque converter
- If there is a malfunction, replace the torque converter with a new one.






- Turbine shaft
- If there is a malfunction, replace the turbine shaft with a new one.






- High clutch hub
- If there is a malfunction, replace the high clutch hub with a new one.






- End cover
- If there is a malfunction, replace the end cover with a new one.


3. Verify that there is no significant sliding trace on the following journal part.






- Ring gear and differential






- If there is a malfunction, disassemble the ring gear and differential and replace the differential gear case with a new one. (See RING GEAR AND DIFFERENTIAL DISASSEMBLY.) (See RING GEAR AND DIFFERENTIAL ASSEMBLY.)






- Drive shaft (LH)
- If there is a malfunction, disassemble the drive shaft (LH) and replace the outer ring with a new one.

NOTE: For the drive shaft disassembly/assembly procedure, verify the service information.






- Joint shaft
- If there is a malfunction, replace the joint shaft with a new one.