Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 2.0]

CAUTION:
- When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing.
- Do not assemble the CKP sensor or change the installation position using any method other than the following. Otherwise, it could negatively affect engine controls, such as the ignition timing and fuel injection.

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable. Removal and Replacement

3. Lift up the vehicle.

4. Perform the following procedure for easier access.
a. Remove the aerodynamic under cover No.2. Aerodynamic Under Cover No. 2 Removal/Installation

b. Remove the front splash shield (RH). Splash Shield Removal/Installation

5. Disconnect the CKP sensor connector.

6. Remove the CKP sensor.






7. Install in the reverse order of removal.