Cylinder Block Inspection

CYLINDER BLOCK INSPECTION






1. Measure the cylinder block for distortion in six directions as shown in the figure using a straight edge and feeler gauge.
- If it exceeds the maximum specification, replace the cylinder block.

Maximum distortion, head gasket side of the cylinder block 0.10 mm {0.0039 in}






2. Measure the cylinder bore diameter using the cylinder gauge. The measurement position is in the X and Y directions at a point 43.9 mm {1.73 in} below the top surface of the cylinder as shown in the figure.
- If it is not within the specification, replace the cylinder block.

Standard cylinder bore diameter 83.50-83.53 mm {3.2875-3.2885 in}