Rear Door Latch: Service and Repair

REAR DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION

1. To access the glass installation bolt, position the rear door glass so that the distance from the top of the rear door glass to the upper part of the rear beltline molding is approx. 210 mm {8.27 in}.






2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Sail inner garnish Sail Inner Garnish Removal/Installation

b. Rear door garnish

c. Rear door trim Rear Door Trim Removal/Installation

d. Rear door speaker Rear Door Speaker Removal/Installation

e. Rear door glass Service and Repair

f. Rear door module panel Rear Door Module Panel Removal/Installation

g. Rear door latch and lock actuator

4. Remove the screw.






5. Remove the rear door latch and lock actuator.

6. Install in the reverse order of removal.