Shift Solenoid A Inspection

SHIFT SOLENOID A INSPECTION [AY6A-EL]

WARNING:
- Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using compressed air.

CAUTION:
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
- Do not damage the terminals.

On-Vehicle Inspection

1. Disconnect the negative battery cable.

2. Remove the fresh-air duct and air cleaner component as a single unit. Service and Repair

3. Remove the TCM. Service and Repair

4. Measure the resistance between coupler component terminal B5 and GND.











- If there is any malfunction, inspect the coupler component for continuity. Testing and Inspection
- If coupler component has no malfunction, perform the "Off-vehicle inspection".

Shift solenoid A specification





Off-Vehicle Inspection

Resistance inspection

1. Measure the resistance between shift solenoid A terminal B and solenoid body.






- If there is any malfunction, replace the shift solenoid A.

Shift solenoid A specification





Operation inspection

CAUTION:
- Do not apply battery positive voltage to terminals for more than 3 s.

NOTE:
- Because the operation sound of the shift solenoid A is small, perform inspection in a quiet place.

1. Connect the shift solenoid A terminal B to the battery positive terminal, connect the battery negative terminal to solenoid body.






CAUTION:
- Do not apply impact to shift solenoid A.
- Do not damage the terminals.

2. Verify that operating sound is heard from the shift solenoid A.

- If there is any malfunction, replace the shift solenoid A.

Airflow inspection

1. Connect the shift solenoid A terminal B to the battery positive terminal, connect the battery negative terminal to solenoid body.






CAUTION:
- Do not apply impact to shift solenoid A.
- Do not damage the terminals.

2. Blow compressed air to inspect the condition of the airflow shown in the figure.






- If there is any malfunction, replace the shift solenoid A.