Reverse Idler Gear Component Assembly Note

Reverse Idler Gear Component Assembly Note





1. Using the SST, install the friction damper to the reverse idler gear.
^ Verify the depth of the friction damper installation position.





2. Assemble the reverse idler gear component.





3. Measure the clearance between the retaining ring and thrust washer.
^ If not within the specification, adjust by choosing the proper retaining ring.

Reverse idler gear end play:
0.1 - 0.2 mm (0.0040 - 0.0078 in)

Reverse idler gear retaining ring








4. Install the reverse idler gear component to the transmission case.





5. Install the reverse idler gear shaft retaining bolt.

Tightening torque:
78.5 - 117 N-m (8.01 - 11.9 kgf-m, 57.9 - 86.2 ft-lbf)