PCM Configuration

PCM CONFIGURATION [LF, L5]

NOTE:
- Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the PCM CONFIGURATION.

1. Connect the M-MDS to the DLC-2.






2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

- When using the IDS (laptop PC)

1 Select the "Module Programming".

3. Then, select items from the screen menu in the following order.

- Select "Programmable Module Installation".
- Select "PCM".

4. Perform the configuration according to the directions on the screen.

5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.

- If a DTC(s) is detected, perform the applicable DTC inspection. DTC Table [Engine]

Wheel And Tire Size change

NOTE:
- Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the PCM CONFIGURATION.

1. Connect the M-MDS to DLC-2.






2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

- When using the IDS (laptop PC)

1 Select the "Module Programming".

3. Then, select items from the screen menu in the following order.

- Select "Programmable Parameters".
- Select "Tire Size" or "Tire Size / Axle Ratio".

4. Select an item name, and then select option.

CAUTION:
- The same parameter should be set in Tire dimension, Tire Circumference and Tire Size.

Items of "Tire Size"
- Tire dimension (195/70R15, 195/65R15, 205/55R16 205/50R17, 225/40R18)
- Tire Circumference (195/70R15, 195/65R15, 205/55R16 205/50R17, 225/40R18)

Items of "Tire Size / Axle Ratio"
- Tire Size (195/70R15, 195/65R15, 205/55R16 205/50R17, 225/40R18)