Engine Technical Data [L3, AJ]

Technical Data

ENGINE TECHNICAL DATA [L3, AJ]:

Cylinder Head (LH)

Tighten the cylinder head bolts in the order shown using the following 6 steps.
(1) Tighten to 32 - 38 Nm (3.3 - 3.8 kgf.m, 24 - 28 ft. lbf)
(2) Tighten 85° - 95°
(3) Loosen 360° (one full turn) in reverse order.
(4) Tighten to 32 - 38 Nm (3.3 - 3.8 kgf.m, 24 - 28 ft. lbf)
(5) Tighten 85° - 95°
(6) Tighten 85° - 95°

Cylinder Head (RH)

Tighten the bearing caps evenly in the order shown in several passes.
After adjusting the camshaft end play using the thrust caps 1L and 6L, tighten the other bearing caps.
Tightening torque 8.0 - 12.0 Nm (82 - 122 kgf.cm, 71 - 106 in.lbf)

Camshaft Bearing (RH)

Tighten the bearing caps evenly in several passes in the order shown.
After adjusting the camshaft end play using the thrust caps 1R and 5R, tighten the other bearing caps.
Tightening torque 8.0 - 12.0 Nm (82 - 122 kgf.cm, 71 - 106 in.lbf)

Crankshaft Pulley
Tighten the new crankshaft pulley lock bolt in four steps.
(1) Tighten to 120 Nm (12.2 kgf.m, 88.5 ft. lbf)
(2) Loosen 360° (one full turn) in reverse order.
(3) Tighten to 47 - 53 Nm (4.8 - 5.4 kgf.m, 35 - 39 ft. lbf)
(4) Tighten 85° - 95°

Oil Pump

Tighten the oil pump bolts in the order shown in the figure.
Tightening torque 8 - 12 Nm (82 - 122 kgf.cm, 71 - 106 in. lbf)

Water Pump

Tighten the bolts to the specified torque, then tighten them further 85° - 95°.
Tightening torque 10 Nm (102 kgf.cm, 89 in.lbf)