Removal and Replacement

DOOR REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the front fender panel.
3. Remove the door speaker.




4. Remove in the order indicated below.
1. Connector
(See Connector Removal Note)
(See Connector Installation Note)
2. Checker pin
3. Door hinge
4. Door
5. Checker


5. Install in the reverse order of removal.
6. Adjust the door.




Connector Removal Note
1. Pull the pin out.

Connector Installation Note

1. Push the pin until it stops.
2. Connect the connector.
3. Repush the pin until it stops and locks the connector.