Direct Clutch Assembly

Assembly Procedure





1. Apply a coat of ATF to new O-rings, then install them to the piston.
2. Apply a coat of ATF to inside of the clutch drum, then install the piston while rotating it by hand.

Note: After installing the drum, ensure that the piston rotates smoothly by hand. If not, the O-ring may be caught.

3. Install the return spring.
4. Position the spring retainer.

Caution: Depress the spring retainer only enough to remove the snap ring. Overpressing will damage the retainer component edges.





5. Install the SSTs in the clutch drum as shown.
6. Install the snap ring.
7. Remove the SSTs.





8. Install the drive plates and driven plates in the order as shown in the figure.
9. Install the retaining plate.
10. Install the snap ring.





11. Place the direct clutch upside down, then install the one-way clutch and retainer.
12. Install the snap ring.