Side Protector

SIDE PROTECTOR REMOVAL




1. Pry the side protector end 20 - 30 mm {0.8 - 1.1 in} using a flathead screwdriver or a razor.

WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.

2. Pull the side protector toward you, then remove it.

NOTE: The side protector is installed with double-sided adhesive tape. If the side protector is difficult to remove, soften the double-sided adhesive tape using a hot air blower.

SIDE PROTECTOR INSTALLATION

1. Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body.




3. Attach double-sided adhesive tape to the side protector as shown (if it will be reused).

Clearance
a: 25.0 mm {0.98 in}
b: 7.0 mm {0.28 in}
c: 1.0 - 3.0 mm {0.04 - 0.11 in}
d: 9.0 mm {0.35 in}




4. Peel off the backing from the double-sided adhesive tape and attach the side protector onto the body as shown.

Clearance
a: 0.66 - 3.66 mm {0.03 - 0.14 in}
b: 7.74 mm {0.30 in}
c: 4.0 - 7.0 mm {0.16 - 0.27 in}
d: 0.5 - 3.5 mm {0.02 - 0.13 in}
e: 3.0 - 6.0 mm {0.12 - 0.23 in}