Displaying & Reading Trouble Codes

- Using jumper wire, short DLC terminal SCN to body GND, turn ignition switch to ON position, and perform past malfunction diagnosis.




DTC TABLE
- DTCs are common for present and past malfunction diagnosis.

NOTE:
- When DTCs not shown in the diagnostic trouble code table are display, replace the SAS control module.
- After a new SAS control module is installed, the air bag system warning light continuously flashes when the ignition switch is turned to the ON position. This is the deployment authorization standby code output by the SAS control module. Perform the deployment authorization and restore the system to an operational state.
- If the air bag system warning light does not illuminate or remains illuminated when the ignition switch is turned to the ON position, inspect and repair the lighting circuit system of air bag system warning light and then confirm that the air bag system warning light is operational.