Condition Detection Mode
INSPECTION OF DIAGNOSTIC TROUBLE CODES FOR CONDITION DETECTION MODEUsing The Cruise Set Indicator Light
NOTE: If the RESUME/ACCEL switch on the cruise control switch has a malfunction, the cruise set indicator light will not give a correct indication when you inspect the system. Use the SST (WDS or equivalent) to determine the cause of the malfunction.
1. Drive the vehicle.
2. Operate the cruise control system and verify that the set, deceleration, acceleration, resume, and cancel controls function by operating each of the control switches.
3. Stop the vehicle and let it idle.
4. Push and hold the RESUME/ACCEL switch for at least 3 seconds. The cruise set indicator light will illuminate for 3 seconds, and then go out for at least 2 seconds.
- If a diagnostic trouble code is indicated, inspect the corresponding system area.
5. The condition detection mode is canceled by turning the ignition switch to LOCK, turning off the cruise control main switch, or driving the vehicle at over 16 km/h {10 mile/h}.
Using The SST (WDS or equivalent) DTCs retrieving procedure
1. Hook-up the SST to the vehicle. Make sure that ignition key is at LOCK and all accessories are OFF.
2. Turn the ignition key to ON (engine OFF).
3. Retrieve DTC by WDS or equivalent.