Front Door: Service and Repair
FRONT DOOR REMOVAL/INSTALLATION1. Disconnect the negative battery cable.
2. To, remove the door hinge, remove the front fender panel.
3. To remove the checker, remove the door speaker.
4. Remove in the order indicated below.
1. Connector (See Connector Removal Note) (See Connector Installation Note)
2. Checker pin
3. Door hinge
4. Front door
5. Checker
5. Install in the reverse order of removal.
6. Adjust the front door gap and height. (See FRONT DOOR ADJUSTMENT.)
Connector Removal Note
1. Remove the rubber boot from the connector.
2. Pull out the connector from the body.
3. Pull the green pin out until it stops.
4. Disconnect the connector.
Connector Installation Note
1. Install the rubber boot on the connector.
2. Connect the connector.
3. Push the green pin until it locks the connector.
4. Install the connector to the body while pushing on both side ribs.