Auxiliary Power Outlet: Service and Repair
ACCESSORY SOCKET REMOVAL/INSTALLATIONNOTE: If the socket is removed, replace the cap with a new one. Do not reuse the cap.
1. Disconnect the negative battery cable.
2. Remove the rear console.
3. Remove in the order indicated below.
1. Connector
2. Socket Socket Removal Note)
3. Cap
4. Install in the reverse order of removal.
Socket Removal Note
NOTE: Two holes (protrusions on the ring) are located opposite each other on the socket.
1. While pushing the protrusion through one of the holes using a tape-wrapped flat head screwdriver, push the back of the socket to disengage the cap from the socket.
2. While pushing the back of the socket, disengage the other side in the same procedure to pull the socket out of the rear console.