General Specifications

WHEEL ALIGNMENT PRE-INSPECTION
1. Inspect the tire inflations, and adjust to the recommended pressure if necessary.
2. Inspect the front wheel bearing play and correct it if necessary.
3. Inspect the wheel and tire runouts.
4. Inspect the ball joints and steering linkage for excessive looseness.
5. Place the vehicle on level ground and unloaded.

Note:
^ Unloaded...Fuel tank full; engine coolant and engine oil at specified levels; spare tire, jack and tools in designated position.

6. Shake the vehicle to settle the suspension.





7. Measure the height from the center of the wheel to the fender brim. The difference between the left and right measurement must not exceed 10 mm (0.39 inch).