3: ABS Warning Light Go On and Off

NO.3 ABS WARNING LIGHT GO ON AND OFF





^ When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunctions. If there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and undamaged.

Diagnostic procedure





Caution:
^ Recheck the diagnostic trouble code after repair completion.

Note:
^ The ABS warning light normally illuminates for 2 - 4 seconds after ignition switch is turned to ON.
^ If any symptoms have occurred in the past but are now okay, malfunction of related harness could be the possible cause and thus ABS CM is normal.