Driver Air Bag Module

WARNING: Handling the air bag module improperly can accidentally deploy the air bag module and pre- tensioner seat belts, which may seriously injure you. Read AIR BAG SYSTEM SERVICE PRECAUTIONS before handling the air bag module. (See Crush Zone Sensor Handling).

1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.




3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Turn the ignition switch to ON position.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
- If the air bag system warning light remains on, off, or repeats flashing after servicing, there are malfunctions in the system. Carry out the inspection again.







Connector Installation Note
1. Install the connector as shown in the figure.







Bolt Installation Note
1. Tighten the bolts in the order shown in the figure.