Displaying & Reading Trouble Codes
INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODENOTE: In this mode, it is possible to check the item in the following chart.
DTC 1 - 31:
Diagnostic Trouble Code Chart
NOTE: The DTC switch are not listed may be indicated, but they cannot be inspected.
Operating Order
NOTE: Wait 30 seconds or more have passed after disconnecting the negative battery cable and connect the cable then operate the input/output check mode again after terminating the input/output check mode.
1. Close the all doors.
2. Disconnect the negative battery cable.
3. Open the driver's side door.
4. Connect the negative battery cable.
5. Perform the following procedures within 30 seconds, after connecting the negative battery cable.
a. Turn the ignition switch to the ON position.
b. Push the door switch 3 times.
c. Push the odometer/tripmeter switch 3 times.
Checking Order
NOTE:
- The DTC are displayed in numerical order. (While performing the inspection, if you want to inspect a DTC whose number is smaller than the code number you are currently inspecting, terminate the check mode then repeat the inspection from the beginning.)
- If rotating the wheels, cancel the input/output check mode.
Check Code 01-14
NOTE: The DTC can be fast forwarded by pushing and holding the odometer/tripmeter switch for 1 second or more.
1. Push the odometer/tripmeter switch and select the DTC.
2. Inspect each DTC by following the related inspection procedures.
Check Code 31
1. Turn the ignition switch to the ACC position.
2. Push the odometer/tripmeter switch and select the DTC.
3. Inspect each DTC by following the related inspection procedures.