Cylinder Head Assembly (II)

CYLINDER HEAD ASSEMBLY (II)





1. Assemble in the order indicated in the table.

Cylinder Head Assembly Note





1. Install the bolts and tighten them in two or three steps in the order shown.

Seal Plate Assembly Note





1. Tighten the seal plate bolts in two or three steps in the order shown.

Camshaft Assembly Note

Caution: Because there is little camshaft thrust clearance, the camshaft must be held horizontally while it Is Installed. Otherwise, excessive force will be applied to the thrust area, causing burr on the thrust receiving area of the cylinder head journal. To avoid this, the following procedure must be observed.





1. Assemble the camshaft onto the cylinder head, facing the cam noses at No.1 and No.3 cylinders as shown.

Camshaft Cap Assembly Note





1. Apply silicone sealant to the shaded areas as shown in the figure.
2. Install the camshaft caps to the positions from which they were removed.





3. Tighten the camshaft cap bolts in two or three steps in the order shown.
4. Apply clean engine oil to the lip of a new camshaft oil seal.
5. Push the oil seal slightly in by hand.





6. Press the oil seal in evenly using the SST.

Camshaft Pulley, VVT Actuator Assembly Note





1. Install the exhaust camshaft pulley with "E" mark straight up.





2. Hold the camshaft using a wrench on the cast hexagon, and tighten the lock bolt.